Jewlery Box

Printing instructions:

Earring / necklace stand: Print the left, middle and right sticks, then print 3 stick bases to insert into, you might have to play with part fitting for them to fit just right, I had to use a little epoxy for mine since it was too loose.
Print 3 earring panels which fit between the left and middle sticks.
The top bar goes on top, obviously.

Base: You Print the base, either whole (if your printer can fit), or halved.

Drawers: Print two drawer box and drwer inners, which should fit nicely under the base.

Assembly: I glued everything together with epoxy.