Thingiverse
JGMaker Magic Improved Part Cooling Duct
by DaHai8
38
Downloads
24
Likes
1
Makes
This is a Slightly improved Part Cooling Duct for the JGMaker (JGAurora) Magic 3D Printer.
Basic improvements over the stock duct include:
+ 3mm separation from the heater block so its doesn't melt like the original
+ air flow directed better to the part below the nozzle tip instead of over to the side
+ vent now centered across nozzle tip instead of mainly in the front
+ can be replaced *fairly* easily without disassembling the print head
See 'Print Settings' below for printing suggestions.
Basic improvements over the stock duct include:
+ 3mm separation from the heater block so its doesn't melt like the original
+ air flow directed better to the part below the nozzle tip instead of over to the side
+ vent now centered across nozzle tip instead of mainly in the front
+ can be replaced *fairly* easily without disassembling the print head
See 'Print Settings' below for printing suggestions.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
