JIOSE Printer Stand with Label Roll

This was a stand I made for my JIOSE printer/labeler so that I could save some room on my desktop. It is separated into 3 main pieces: Board, L Leg, R Leg. Then the roll is separated into 3 pieces as well: Axel, Peg (L) and (R). There is only 1 Peg file so just print it twice. I've included a picture so you can see how to assemble the Stand. I put 2 holes at the top that will fit a M4 screw to hold the Board to the Legs. I don't have a screw in mine since it fits very well together but I put a spot for a screw to make sure its solid. The label roll will have the Axel placed through the center of the roll with the Pegs installed into the Axel on each end. The whole assembly will slide into the indented spot at the center of the legs. The roll should open up on the bottom towards the back so that it can feed into the printers input area at the back of the printer. I'm not sure it will fit other labelers but I hope so if you don't have a JIOSE printer/labeler. I also included the STEP f