jjrc h6c prototype frame 3

Most likely my final iteration of this frame for the jjrc h6c.This frame was built for performance. Main frame sliced in cura, 0.2 layer height, 16 percent infill, .4 height for top and bottom layers (+/- affects screw hole rigidity). Other parts printed at 50-100 percent infill. No raft or supports needed if printed in the right orientation.

Main frame has it's rigidity focused in the x axis, also z with stepped surface I-beam design, while lower frame and I-beam brace are in the y axis. Foot is .8mm thick for reduced weight. mbrace part can be used in place of lower cambrace part, for detaching camera for reduced weight.

Added the camera mount. Take care not to bend the flat flex connector as these are delicate. Board can be tricky to insert into cage, and should only be inserted in one orientation (from the top), then the frame bent a bit to snap it in gently.

Edit: Getting rolling shutter effect with the camera mount. Not sure how to get rid of this, perhaps printi