JMC Red Dwarf

The JMC Red Dwarf

huge fan of the series wanted to make my own version of the original ship may add the different rear section (circle type with multiple engines) in the future made a few modification since my print let me know if it doesn't fit properly so it can be adjusted.

my print was separate so not sure how the combined full ship would print may work in 3 parts?

sides panels are all the same so you can mix and match whatever sides you want

added a few photos so you can see how the rear brace and internal braces work,
used spare 1.75 filament between the front scoop braces and as extra pipe work as you can see

slope details are mostly domes and lines to add extra effect to front and rear or the panels if you want more detail also has "pipe work' fittings so you can run filament across to different areas with out drilling holes

total ship length is 44cm if printed at 100%

I printed most with a .2 layer size and 10% infill on most parts to speed up printin