Thingiverse
JMI Wheeley Level Adjuster
door Hume
0
Downloads
0
Likes
0
Makes
It's just a simple print of a device to use on my drill to raise and lower my tripod dolly. This works with the leveling screw handles of the JMI Wheeley Bars. I purchased the leveling screws to use on my homemade tripod dolly. I used a 3/8" coarse bolt about 6" in length and just chuck the threaded end in my drill.
Print upside down and depending on your printer you might need supports for the top bevel
Printed in PETG or any reasonable strong material. I used PLA and it works well enough.
I did add some wall for strength and used Gyroid infill at 25%. Probably overkill.
Printed on a CR6-SE
Print upside down and depending on your printer you might need supports for the top bevel
Printed in PETG or any reasonable strong material. I used PLA and it works well enough.
I did add some wall for strength and used Gyroid infill at 25%. Probably overkill.
Printed on a CR6-SE
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
