Thingiverse
John Keychain
von Shippu7
2
Downloads
4
Likes
0
Makes
This print is layered based on colors. If you do not want to change filaments, then print in white and fill in the colors via brush.
Slice at .3mm layer ht.
Start with white/cream
Switch to orange
Then finish with black
Slice at .3mm layer ht.
Start with white/cream
Switch to orange
Then finish with black
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
