Thingiverse
Jointed Army men
door Robot3dart
31
Downloads
85
Likes
0
Makes
This is army men model that requires manual assembly, capable of limited articulation after assembly.
-------------
Print Settings
Layer height:0.2mm
speed:200mm/s
Need support
5% infill , 3 walls
Print Time : ~4 hours
Recommended to use PETG for printing.
If the joints are too loose or too tight, please adjust the X-Y contour compensation by approximately ±0.05
-------------
Print Settings
Layer height:0.2mm
speed:200mm/s
Need support
5% infill , 3 walls
Print Time : ~4 hours
Recommended to use PETG for printing.
If the joints are too loose or too tight, please adjust the X-Y contour compensation by approximately ±0.05
Robot3dart publiceert ook op
7 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
