Thingiverse
Jointed Rhino
door Robot3dart
94
Downloads
362
Likes
1
Makes
This is rhino model that requires manual assembly, capable of limited articulation after assembly, though the rhino does not have many possible display poses.
-------------
Print Settings
Layer height:0.2mm
speed:200mm/s
Need support
5% infill , 3 walls
Print Time : ~5 hours
Recommended to use PETG for printing.
If the joints are too loose, adjust “X-Y contour compensation” to 0.05 ~ 0.1. If they are too tight, adjust it to -0.05 ~ -0.1.
-------------
Print Settings
Layer height:0.2mm
speed:200mm/s
Need support
5% infill , 3 walls
Print Time : ~5 hours
Recommended to use PETG for printing.
If the joints are too loose, adjust “X-Y contour compensation” to 0.05 ~ 0.1. If they are too tight, adjust it to -0.05 ~ -0.1.
Robot3dart publiceert ook op
7 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
