Thingiverse

Jointer blades sharpening jig

by geo0258

98 Downloads

63 Likes

0 Makes

Hi everyone. I designed a jointer blade sharpening jig.

This jig is made for blades with a 40° bevel and 258mm long. The space between 2 holes is 51mm so if you have the same space you can use this jig even if the total length of your blade is different than 258mm

I used m4 screws to hold the top with the bottom. You have to print twice the top, but it is not mandatory, it can work only with the bottom, some screws and washers as well.

You have to print it flat and not standing like on the picture. Check out the video linked to see the setup I have used to print it and how I sharpened my own blades. No supports were needed with my settings
Link of the vidéo here : https://youtu.be/qUepuS66eJk

Jig Jointer Knife Sharpener makeithappen make it happen planer Planer Blade sharpening jig thickness planer Jig Jointer Knife Sharpener makeithappen make it happen planer Planer Blade sharpening jig thickness planer

Source

Thingiverse

What you need to print this: Beginner Low confidence

Why?

no supports

Support-free Single piece Hardware needed

Supports 0/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer