JonsBo DS8 Deskstand

This thing has some remixed parts from the original "Angled Screen Mount" found here : https://www.thingiverse.com/thing:6336220/files

I bought the DS8 screen without case and needed it to stand on the desk, so i saved the frame and clips from the original thing and added a "foot" so it can stand.

About the stand:
The screen sits in an angle of 25 degrees and is hold in by some small clips
Easy to click in and easy to remove again.
Stand has a good balance and requires some forge to tilt over
Clips hold's the screen in place and wont drop out, see pictures

Printing:
Place the frame with front down on build plate, use support for the arc,i recommend tree support on Cura.
Place the clips where you like :), or print them first and the frame second

After print:
remove support also from the holes in the frame, and that's it

Assembly:
Superglue the clips into the holes in the frame and voila your DS8 screen clicks in ad do not fall out.

Printet in PLA
Support: yes

Printtime on CR6SE i