JoyCon Controller Grip v3.1

MembershipDo you want to sell physical prints of this or any of my other models? Join my commercial license membership to be granted a commercial license! This was an experiment. My other JoyCon grips print flat on the bed in one piece, which is great for simplicity, but it means that the back of the grip is flat and can't be rounded unless using a fillet against the bed which is a no-no in my book. My compromise was to print the main body and triggers separately. The main body is printed at an angle so as to not need any supports while allowing the handles to be rounded which is far more comfortable in my opinion. The triggers are attached to the main body using one M3x14 SHCS. Be careful not to overtighten the screw as it is screwed into plastic and the triggers can become loose if the plastic is stripped. UPDATE Oct-29-2024 I received some feedback that the universal body could allow the inserted JoyCon to rock if too much pressure was applied to the JoyCon on one side. I have uploa