Thingiverse
JST HX Extractor
door dont-knock-it
9
Downloads
4
Likes
0
Makes
I needed a JST XH extractor tool, and found the original a little fragile, so decided to remix it, but this is mostly a completely new model. I wanted the finger area to be cupped to make the grip a little safer.
The pictured one was printed in PLA at .2mm, using the included support file to allow bridging.
The pictured one was printed in PLA at .2mm, using the included support file to allow bridging.
dont-knock-it publiceert ook op
21 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
