Thingiverse
Jump Mech MK 2
por Doiboy35
11
Descargas
8
Likes
1
Makes
This is my update to my Jump mech utilizing the new joint design along with some other small tweaks to the model.
1/19/23 Fixed issue where one of the feet had a line on its sole, should not appear anymore.
The Jump Mech MK 2 was designed with a focus on simplicity, durability, and ease of printing.
Joints are achieved through a system of 3mm pins that give just enough friction while also easily removed with pliers (for maximum strength, print these so that the long side of the pin is parallel to the build plate).
3 millimeter ports on the arms, legs, and back allow for cross compatibility with most other model kit accessories.
I hope you enjoy. Please send feedback as I may create improved versions of the figure in the future.
Depending on your printer and plastic, some light sanding and/or tightening of parts may be required. Tightening may be done via thin layers of super glue or multi-surface floor polish.
1/19/23 Fixed issue where one of the feet had a line on its sole, should not appear anymore.
The Jump Mech MK 2 was designed with a focus on simplicity, durability, and ease of printing.
Joints are achieved through a system of 3mm pins that give just enough friction while also easily removed with pliers (for maximum strength, print these so that the long side of the pin is parallel to the build plate).
3 millimeter ports on the arms, legs, and back allow for cross compatibility with most other model kit accessories.
I hope you enjoy. Please send feedback as I may create improved versions of the figure in the future.
Depending on your printer and plastic, some light sanding and/or tightening of parts may be required. Tightening may be done via thin layers of super glue or multi-surface floor polish.
Doiboy35 también publica en
17 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
