Thingiverse
Jumping Bug Spider
von Petal3D
5
Downloads
4
Likes
0
Makes
Wind up your spider, let it go and watch it go! No batteries required.
For assembly instructions, refer to my video:
https://youtu.be/TatN_oUOGYs
Print both halves with about 20% infill and no supports. Paint the pieces in your scariest colour scheme and allow to dry.
Use epoxy to join both halves of the mechanism together. When glueing, ensure that the key on the mechanism is centralised in the hole and that the alignment holes are in line.
If you want, you may add hair to your spider.
The jumping Bug Spider was designed in ViaCAD.
A suitable windup clockwork mechanism is available from https://www.scorpiotechnology.com.au/
For assembly instructions, refer to my video:
https://youtu.be/TatN_oUOGYs
Print both halves with about 20% infill and no supports. Paint the pieces in your scariest colour scheme and allow to dry.
Use epoxy to join both halves of the mechanism together. When glueing, ensure that the key on the mechanism is centralised in the hole and that the alignment holes are in line.
If you want, you may add hair to your spider.
The jumping Bug Spider was designed in ViaCAD.
A suitable windup clockwork mechanism is available from https://www.scorpiotechnology.com.au/
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
