Thingiverse
Just Another Filament Spool Rack
von Bastion-0078
0
Downloads
2
Likes
1
Makes
The OpenSCAD code was generated by Gemini 3 Pro. None of it was made by me.
I wanted a rack that uses M8 rods because I had some lying around. I wanted it without having to spend an hour fiddling in FreeCAD.
You can modify the holes in the OpenSCAD File and use anything as rod you want or have lying around.
The dovetail clearance in the STL is set to 0.05 mm. Change this value to suit your printer's tolerances. You can cut the model into two parts to print them separately, or merge them if your printer is large enough. You can also change the position of the dovetail in the OpenSCAD file. Make sure to measure your nuts and washers before printing!
I wanted a rack that uses M8 rods because I had some lying around. I wanted it without having to spend an hour fiddling in FreeCAD.
You can modify the holes in the OpenSCAD File and use anything as rod you want or have lying around.
The dovetail clearance in the STL is set to 0.05 mm. Change this value to suit your printer's tolerances. You can cut the model into two parts to print them separately, or merge them if your printer is large enough. You can also change the position of the dovetail in the OpenSCAD file. Make sure to measure your nuts and washers before printing!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
