Thingiverse
Just Another MOSFET Case
door akf_was_here
3
Downloads
1
Likes
0
Makes
A little enclosure for a Wang DD 22 mosfet, really designed for screwing to a base like mdf.
Shield and carrier should print without supports as oriented. Shroud may need internal supports for the overhang though my friend has printed it fine without. Photos are from an early design that had a separate fan grate piece - this is now integrated into the fan shroud piece.
The fan shroud has holes for a 40mm cooling fan to cool the heat sink.
The shroud and shield hold the wang carrier down to a base via pressure once they are screwed into a base.
Wang carrier holes are threaded M3x0.5 x5mm deep.
Shield and carrier should print without supports as oriented. Shroud may need internal supports for the overhang though my friend has printed it fine without. Photos are from an early design that had a separate fan grate piece - this is now integrated into the fan shroud piece.
The fan shroud has holes for a 40mm cooling fan to cool the heat sink.
The shroud and shield hold the wang carrier down to a base via pressure once they are screwed into a base.
Wang carrier holes are threaded M3x0.5 x5mm deep.
akf_was_here publiceert ook op
37 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
