Just Venus HueForge

Source - real planet image @Kevint M.Gill / May 17, 2016Then used HueForge v0.8.1 to create the model. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.Size 200x200mm. Do not adjust the height (Z) in your slicer! The layers would not be correct. You can only modify the X and Y dimensions. You may print at higher layer heights below the Min Depth of 0.56mm. The Max Depth is 2.2mm and the Actual Depth is 2.2mm It is possible to print without AMS by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support. Filaments Used:PLA Elegoo+ Black Transmission Distance: 0.3PLA Sunlu META Grey Transmission Distance: 3.6PLA BambuLab Basic Jade White Transmission Distance: 5PLA Elegoo + Gray Transmission Distance: 3PLA Creality Skin Transmission Distance: 6This print uses 5 unique filaments Swap Instructions:Start with BlackAt layer #7 (0.64mm) swap to GreyAt layer #11 (0.96mm) swap to Jade WhiteAt layer #1