Thingiverse
K-Cup Counter Holder
door mikehunt7272
62
Downloads
40
Likes
0
Makes
I needed a clean and simple K-Cup holder for my counter. Everything out there was too big. Someone sells something like this in clear acrylic for $30 so I decided to make one. It's worked out really well.
The tolerance on the holes is loose enough you should not have to adjust at all. I tried on an UPBOX+ without supports and that didn't work well, but great with supports. It cleaned up with little effort.
One last note - turn it on it's side at 45 degrees and you'll have the least amount of filament used.
The tolerance on the holes is loose enough you should not have to adjust at all. I tried on an UPBOX+ without supports and that didn't work well, but great with supports. It cleaned up with little effort.
One last note - turn it on it's side at 45 degrees and you'll have the least amount of filament used.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
