K-Cup Ninja Dispenser Extension

This extension adds 100 mm (4”) to the top of the linked 249 mm high K-Cup dispenser. This took the original dispenser design, cut the top 2” off, duplicated it, and then stacked the two. I then added a new STL for pins and alignment tabs. A second STL block was added to the back to eliminate the unneeded indent. The print image is printed upside down.  A separate STL file is used as a drill template to the top of the original dispenser where you drill two 3/16” holes. I didn’t glue it on top, but you could if desired.