K1 Max Cable Chain Delete using Cable Tie V2

I have removed K1 Max Cable Chain and replaced it with 500mm x 7.4 (8mm) Cable Tie.
I did not want to use a riser and keep the cable horizontal.
Cable Mount 5 Deg has upwards angle to help offset cable sag.
Need to cut off the triangle tip and lock off the cable tie so ends are square and chamfer corner and max length with teeth pattern.
Need to cut cable tie to correct length to match your printer cable chain. 20mm of cable tie is inserted into the printed links.
V2 using original rear and tool head mounts and use a link to interface to cable tie and allow more swing,
FLAT version adds more strength to tool head mount as it was breaking on layer line when printer vertical and inserted into chain link.
Print with Brim, and supports where need.