K1 Max chain drag fix

K1 Max chain drag fix. (This is a work in progress so I may make edits if things change or come up.)

These parts support the the chain on the extruder side and rear frame side

Rear ramp just slides over the existing chain tray in the rear.
For the extruder side support, remove the chain screw (has Red Loctite, so its tight) lift the chain end enough to slide the open edge of the new part under it from the right, around the wires, then rotate 90 degrees so the opening is facing rear. Press it down over the square screw post and the part should fit flat and snugly behind the edge of the extruder cover.

I also added a few small pieces of super thin 2 sided tape (.01 mm without the backing) to hold the extruder part securely and prevent any type of movement (it's a snug fit anyway but wanted a little extra).

After installing the rear "ramp", also loosen the two, 2mm hex screws that secure the rear end of the chain assy to the frame (behind the black cables), lift slightly and tighten