K1 Max Heated Chamber

This is a bracket that allows you to mount a 500 watt heater to the side of the K1 Max printer. I made this to improve my ABS/ASA/ PC prints however, this is a heating element which can cause fires. I AM NOT AN ELECTRICIAN AND I DO NOT KNOW IF THIS FOLLOWS REGULATIONS. YOU TAKE FULL RESPONSIBILITY IF YOU COPY THIS DESIGN.

Parts List:
-500 Watt Amazon Basics Heater https://www.amazon.com/gp/product/B074MX8VN5/ref=ewc_pr_img_1?th=1
-W1209 Digital Temp Controller https://www.amazon.com/gp/product/B0CZ6X28CG/ref=sw_img_1?smid=AAEB9VLHZ4H91&psc=1
-12v power supply https://a.co/d/8CiZ0bt
-Misc Hardware

First, you need to know a little about circuits.
1. Disassemble amazon heater, remove tip over switch and reroute the switch wires to the back of the unit through the same hole that the power cord enters. You do not need the tip over switch because you will be mounting the heater permanently. (Leave the power switch connected)
2. Connect tip over wires to the relay in the W1209 c