K1max Door Gap

K1max door gap I print a lot of ABS, ASA, and other high temp materials and want to eliminate the long gap at the side of the door glass. Been testing this mod for about a month now with no issues. Since the door moves inward on the hinge side needed to offset the bracket a little. The 2 models are designed to snap together you can use glue if you want but I didn't and haven't had any trouble with them coming a part. It mounts with the top left side screw that holds the side panel on and the bottom hinge screw. This model requires changing out 2 screws and felt tape. I printed this model in ABS with both models on the build plate like picture shows need just a little support for the bottom model. If you are printing a lot of high temp would not recommend printing in PLA would warp in time.hardware1-M3 x 12 screw1- M3 x 12 course thread (if I remember correctly one of the package shipping screws that hold bed during shipping can be used)felt tape or foam tape 1/2 inch wide 1/4 inch thickAs always Comments and feedback welcome.