K2 Plus Print Head Cable Brace

There is a problem with the K2 plus, and likely the other K2 models as well, where the wire that attaches to the print head is at a hard 90 and can fail. I have created a replacement attachment that attaches to the screw holes already on top of the print head that removes the 90 that causes the cable to fail. I have been getting constant BM2355 errors every time I would print and have not gotten it once out of 15+ prints ever since installing this piece.

You will need to use 2 M3x6 screws to hold on the top cover where the chain connects. Also, you will have to remove the last piece of the guide chain in order to keep that from binding. I also added a cable tie to the cable and the top portion of the last cable chain to keep it from rubbing on the bottom part of the chain, but I'm not sure it is necessary. I just did it to prevent any future issue with the rubbing.