Thingiverse
K40 equipment
von zer0flag
3
Downloads
1
Likes
0
Makes
Additional parts I used for my K40 Laser. I bought the older model with analog power adjustment. Newer version seen to have other screws for the airflow.
1) K40-adapter: This is an adapter to connect the K40 air hose to an 125 mm, Mine is called "Rohrlüfter/Einschublüfter VKO - verengt 125mm" at amazon.de
2) Luftansaugung: Air hose inside the laser cutter. Shorter than the original part to be used with an high adjustable table, but better air flow.
3) LED-Ring v3: My version of the led-ring to mark the actual laser position. Glue 4 magnets 10x3 mm into the deepenings to hold the ring. The led-ring is a 8bit WS2812 5050 5V ring with 32 mm diameter.
4) Kabelhalter Magnet: Same principle as with the led-ring. Glue two 10x3mm power magnets. Holds cables to the casing and can be removed easily.
To be continued...
1) K40-adapter: This is an adapter to connect the K40 air hose to an 125 mm, Mine is called "Rohrlüfter/Einschublüfter VKO - verengt 125mm" at amazon.de
2) Luftansaugung: Air hose inside the laser cutter. Shorter than the original part to be used with an high adjustable table, but better air flow.
3) LED-Ring v3: My version of the led-ring to mark the actual laser position. Glue 4 magnets 10x3 mm into the deepenings to hold the ring. The led-ring is a 8bit WS2812 5050 5V ring with 32 mm diameter.
4) Kabelhalter Magnet: Same principle as with the led-ring. Glue two 10x3mm power magnets. Holds cables to the casing and can be removed easily.
To be continued...
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
