K40 Laser Air Assist Solution

This K40 air assist solution consists of 3 printed parts:

(1) Nozzle (creates low volume airflow exiting the laser lens area to prevent smoke or vapor from settling on the lens)
(2) Splitter (directs most of the airflow through a blower tube at the site of the cut, and a lower volume of air to the nozzle)
(3) Clamp (holds the blower tube for directing air onto the cut site)

You will need to make the blower tube for directing air at the cut site. I used a set of nested copper tubes soldered together to direct the air and increase air velocity by decreasing the tube diameter at the air exit. You can bend copper tubing without collapsing it by packing it with sand or salt first. Soldering can be done with electrical solder and a small micro torch (use solder flux).

I used PTFE tubing (same kind as used in FDM printers for 1.75mm filament paths) for the Nozzle, and 0.25 inch ID silicone tubing everywhere else.

The nested copper tubing I used: K&S Precision 3404 Round Copp