Thingiverse
k40 laser door stop
von raptor_demon
143
Downloads
63
Likes
0
Makes
this is a door stop designed for the k40 to help with camera alignment with lightburn.
the door was going too far back. the back holes are 6.2 mm to allow 6 mm magnets to be glued in.
print flat on the long side without supports
the door was going too far back. the back holes are 6.2 mm to allow 6 mm magnets to be glued in.
print flat on the long side without supports
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
