Thingiverse
K40 Trash-Hook :-)
door TrixiN
0
Downloads
1
Likes
0
Makes
A little tool to get "all those little friends" that fall down when cutting.
I think, therefore the CN's made the (stupid?) holes in the bottom of the housing.
When you get one with wheels, you have enough space to clean the waste when pushing it through those holes.
But: i didn't have wheel, and the space is very small.
So i "developed" this Trash-Hook to collect all the little parts etc. and move them to the front side into a trashbox or so.
Its made from 3 mm plywood, and two of them are glued together, so the heigth is fitting the maximum available space - could be more, but there are the heads of screws for fixing the ugly stock bett, which will limit the space A LITTLE
I think, therefore the CN's made the (stupid?) holes in the bottom of the housing.
When you get one with wheels, you have enough space to clean the waste when pushing it through those holes.
But: i didn't have wheel, and the space is very small.
So i "developed" this Trash-Hook to collect all the little parts etc. and move them to the front side into a trashbox or so.
Its made from 3 mm plywood, and two of them are glued together, so the heigth is fitting the maximum available space - could be more, but there are the heads of screws for fixing the ugly stock bett, which will limit the space A LITTLE
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
