Thingiverse
Kanto Pokemon Badges
by lordgarth6
64
Downloads
57
Likes
2
Makes
i printed these at this fine of a resolution for easier post processing because i used some plasto model putty to fill the layer lines and sand down easily. then i just poured some enamel paint on top and let it drip off so no brush lines. still got to paint some details on some but their 90% painted. all designed in fusion 360 and then some were smoothed out in meshmixer.
these use 3mm thick, 8mm diameter magnets and i found most fit flush with a little bit of force and no need for glue but thats all down to each persons printer.
these use 3mm thick, 8mm diameter magnets and i found most fit flush with a little bit of force and no need for glue but thats all down to each persons printer.
lordgarth6 also publishes on
3 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!