Karearea Talon PR pod/canopy prototype

pod/canopy for Karearea Talon PR, brings the camera back to the front of stack and has a fin for both turtle mode and also affects cornering.
Please keep in mind this pod has been tested primarily on a track set up in a well maintained sports field, so crashes are limited to gates, flags and soft grass
Designed for 19mm cameras with 8mm lens, and includes a hole inside the fin for a dipole whip antenna
camera angle range in 45-65 degrees, but you should be able to widen that with a dremel if needed, and may need to dremel if lens is shorter and pod is in view
we have tried many materials including 95 shure hardness TPU, however the only print material i can recommend is PolyMax PLA by Polymaker with 80% infill. It is much stronger than regular PLA and ABS, and doesn't have any of the layer separation issues.

for 95 shure hardness TPU the walls would need to be thicker as it was designed with a more rigid material in mind.
(UPDATE)
I have added an stl which has been thickened