Thingiverse
KatVR Kat Walk Controller Hook
door AtomicGuild
0
Downloads
0
Likes
0
Makes
My "knuckles"-style straps didn't fit around the knob of my KatWalk, so I made this instead.
This design is intended to go on the right side, since the water bottle holder is on the left, but the model can be mirrored in your slicer if you want to put it on the other side.
To install, remove the two screws from the back of the mid-level retaining bracket, put in place, then reinstall screws. Works with or without the Sit Module.
This design is intended to go on the right side, since the water bottle holder is on the left, but the model can be mirrored in your slicer if you want to put it on the other side.
To install, remove the two screws from the back of the mid-level retaining bracket, put in place, then reinstall screws. Works with or without the Sit Module.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
