Thingiverse
Kayfun Lite 510 Drip Tip
von IchHalt
11
Downloads
9
Likes
0
Makes
Hi there,
this is the driptip, the kayfun lite originally has. it is a 510 driptip, very small and short. Size of driptip is 8.5x15mm (OD x L). It should be your first choice for small e-cig setups. O-ring size is 6x9x1,5mm (ID x OD x W). You'll get these from spare parts of the kayfun lite clone replacement set.
Due to its thin wall thickness, I would recomend to print that driptip lying on its side, the bore should be positioned horizontal, like on the picture. Additionally the printed lines of the PLA/ABS will resist buckling forces. Then you''ll guarantee, that it won't break by the o-ring chamfer. Very robust then.
Print this in 0.1 mm lying on its side. 100% infill is nice.
Good luck and vape on
this is the driptip, the kayfun lite originally has. it is a 510 driptip, very small and short. Size of driptip is 8.5x15mm (OD x L). It should be your first choice for small e-cig setups. O-ring size is 6x9x1,5mm (ID x OD x W). You'll get these from spare parts of the kayfun lite clone replacement set.
Due to its thin wall thickness, I would recomend to print that driptip lying on its side, the bore should be positioned horizontal, like on the picture. Additionally the printed lines of the PLA/ABS will resist buckling forces. Then you''ll guarantee, that it won't break by the o-ring chamfer. Very robust then.
Print this in 0.1 mm lying on its side. 100% infill is nice.
Good luck and vape on
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
