Thingiverse
Kazoo
von cr8n
4
Downloads
15
Likes
0
Makes
Someone asked me if you could print a kazoo. Yes you can. In fact here is one you can print.
I designed this pretty quick and it prints well, only needing support for the overhang on the Plug.
Once printed, cut a piece of wax paper the diameter of the opening in the top of the kazoo (about 26mm) and then press the Plug down over it.
I designed this pretty quick and it prints well, only needing support for the overhang on the Plug.
Once printed, cut a piece of wax paper the diameter of the opening in the top of the kazoo (about 26mm) and then press the Plug down over it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
