Kbar - Little Stinker

This is the "Little Stinker" the younger and much lighter sibling of the McStinky.

These are minimal, ultra light weight TPU mounts for your tinywhoop racing needs. Individual prints may vary but these should come out at or below 0.3g

Currently available for the Tinywhoop Pinch 30-50deg every 2.5deg.

To get them to sit at their printed angle on the whoop, make sure there is something at the same hieght as the top of the FC mounts on the FC for the canpoy to rest on. I use a small piece of thin VHB stuck to the FC, it provides a bit of cushion and sets it to the right height.

No special high end printer, I use an old Sovol SV01 Titan. These parts where designed to be printed with 0.4mm nozzle and 0.2mm layer. Make sure you know the correct temperature your material likes to be printed at and that it is good and dry. Supports are included in these files and should be fairly easily removed. Give the center support a good pull with some small pliers on each side, it should s