Thingiverse
KCX_RADIO
von kote315
1
Downloads
1
Likes
0
Makes
Radio reciever based on KCX_RADIO
There are a few flaws, such as misaligned holes for mounting the board, but I'm too lazy to fix that - just use glue!
The back cover has a mount for an 18650 battery (it is assumed that the battery will be held in place with glue, and you will attach the wires yourself). There is an option without a battery mount - use it if you want to install a flat battery (glue it to the back wall).
The diameter of the place for the speaker is 60.5 millimeters. I used some Soviet speaker with a small magnet (not sure what model exactly - something like 0,1 ГД-6 or 0,25 ГДШ-1-10 or 0,2 ГД-1). A speaker with a large magnet may interfere with the battery.
For the FM/SW antenna I simply used a piece of wire and drilled a hole in the side for it. I did not add a MW antenna or a connector for it.
When printing buttons, use the smallest possible line width, especially for the top layer, to make the symbols more readable.
There are a few flaws, such as misaligned holes for mounting the board, but I'm too lazy to fix that - just use glue!
The back cover has a mount for an 18650 battery (it is assumed that the battery will be held in place with glue, and you will attach the wires yourself). There is an option without a battery mount - use it if you want to install a flat battery (glue it to the back wall).
The diameter of the place for the speaker is 60.5 millimeters. I used some Soviet speaker with a small magnet (not sure what model exactly - something like 0,1 ГД-6 or 0,25 ГДШ-1-10 or 0,2 ГД-1). A speaker with a large magnet may interfere with the battery.
For the FM/SW antenna I simply used a piece of wire and drilled a hole in the side for it. I did not add a MW antenna or a connector for it.
When printing buttons, use the smallest possible line width, especially for the top layer, to make the symbols more readable.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
