keltec RDB dust cover

To be used with an *****armalite-10**** dust cover as shown in the comment section, a 15 style will leave gaps. I designed this to work with PETG, but PLA is also great!

Make sure your printer is calibrated. Cheating your calibration by using the hole expansion adjustment will cause fit issues.

If you end up using my design, think about buying me a cup of coffee? I drink the cheap stuff, but unfortunately the rounds I used to test this out were not.

Parts:
-Ayy Arrr 10 dust cover
-4x(M3-0.5 x 12mm).

I recommend twisting the dust cover spring twice upon install.

Supports necessary.
Prints fine with a few walls and ~15% infill, but up to you!

The flat bottom file is easier to print and that's the only difference besides slightly wider dust cover rod holes. I'd recommend doing that one.


https://www.youtube.com/channel/UCf3DO2qmtMm_mKAhJWn4QDw/featured

^videos around dust cover

I also added my old design that clips in and Zip ties down (the one in the v