Keter Moby Recycling Bin Clip

This is a replacement for broken or lost Keter/Kis Moby (outdor) Recycling Bin clip that should hold garbage bags attached to metal rods, created because I was not able to find such item in vendor's assortment. It should fit on 7mm diameter rods.It fits pretty tight, may require a bit of tilting in order to take it off from the rod. I printed it with Sunlu PETG filament, 15% of infill to have some level of elasticity, and 3 walls for durability.It was also printed with handle parallel to the printer bed, with added support (in Cura: normal support, touching build plate, lines) to give some strength to the part that holds to the rod. (Please be aware that depending on the printer and printing settings, after removing the support one side can be a bit rough, but still not unpleasant or unusable.) NOTE: It was just designed and tested if fits on the rods - it was not used for a long time therefore I am not able to predict the lifetime of this clip. However, the time to have it printed