Thingiverse
Keter SIGMA caps
von confuded
3
Downloads
2
Likes
0
Makes
Fits perfectly the Keter Sigma series shelves. Bough 4 sets and didn't want the 5th shelf so I made a 5th set of shelves, but was missing the caps.
These aren't the most optimized thinness wise and in general a very amateur model made in Meshmixer - but hey, they work! Fit quite nicely! Had to iterate a few times to get a snug fit.
NOTE: Printed using 0.8 nozzle for speed (nearly quadruples the speed!).
These aren't the most optimized thinness wise and in general a very amateur model made in Meshmixer - but hey, they work! Fit quite nicely! Had to iterate a few times to get a snug fit.
NOTE: Printed using 0.8 nozzle for speed (nearly quadruples the speed!).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
