Kettlebell Floor Protector \ Stand

I like to work out at night when my household is asleep. I have a 40lb kettlebell and when it's dead quiet at night it kind of feels like I'm shaking the house putting it down. I made this pad to set it on out of TPU. It's designed to provide a little cushion setting it down and protect the floor from being scratched. It can also keep it from rolling around as much if you put it in your car. It can be printed in PLA, but TPU gives it a very nice cushion and dampens the sound more. Just make sure you dry you TPU well before printing for the best finish. The flat spot on the bottom of my kettlebell I designed it for is 95mm or about 3-¾" in diameter. You may need to scale it up or down accordingly if you want it sized to your equipment specifically. Below is a table for scaling. Measure the flat spot on the bottom as seen in the photo and then input that value accordingly in the slicer. Boost MeAny boosts are greatly appreciated! Thanks! Target Size (mm)Percent Scaling (%