Thingiverse
Keurig K-Cafe Riser
door 5dot5six
6
Downloads
8
Likes
0
Makes
This is a riser for the Keurig K-Cafe to prevent splashing. It sounds like Keurig may have different designs. Recommend printing a small piece to test fit interfaces before printing the entire part.
******UPDATE******
Addressing some questions from a fan:
What height coffee cup will fit with this riser? Great question! - A 4.25" (108mm) tall cup should fit just fine.
Are the tolerances of this model exceedingly tight? Another great question! - Since tolerances are typically called out on a 2D print and are not part of the 3D model I can't really say. Any variability would be determined by the accuracy of your 3D printer.
Couldn't you have mimicked the original design? Dynamite! - I could have done a lot of different things, but this is what I threw together and has worked well for me for over two years.
How can I tell if this will fit properly? Another fantastic question! - If you are concerned about this print, or any print, fitting properly...I would recommend printing test
******UPDATE******
Addressing some questions from a fan:
What height coffee cup will fit with this riser? Great question! - A 4.25" (108mm) tall cup should fit just fine.
Are the tolerances of this model exceedingly tight? Another great question! - Since tolerances are typically called out on a 2D print and are not part of the 3D model I can't really say. Any variability would be determined by the accuracy of your 3D printer.
Couldn't you have mimicked the original design? Dynamite! - I could have done a lot of different things, but this is what I threw together and has worked well for me for over two years.
How can I tell if this will fit properly? Another fantastic question! - If you are concerned about this print, or any print, fitting properly...I would recommend printing test
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
