Thingiverse
Key Storage
5
Downloads
3
Likes
0
Makes
Thingiverse does not think I should do remixes... this was the inspiration.
https://www.thingiverse.com/thing:2371630
This will hold your keyfob against a steel entry door or your fridge.
This is sized for a 2019 Camry, source files are available for you to customize.
The cavities in the back are undersized (0.15mm) to have the 6mm x 5mm magnets press in.
(No press needed, wrap tape around the lower jaw of adjustable pliers and squeeze... gently)
There is room around the magnet for epoxy if you need/want it, but I did not need it.
I included a boring keyholder that printed in ~3 hours at .2mm layer height and 70mm/s as well so you can put whatever or nothing at all on top.
https://www.thingiverse.com/thing:2371630
This will hold your keyfob against a steel entry door or your fridge.
This is sized for a 2019 Camry, source files are available for you to customize.
The cavities in the back are undersized (0.15mm) to have the 6mm x 5mm magnets press in.
(No press needed, wrap tape around the lower jaw of adjustable pliers and squeeze... gently)
There is room around the magnet for epoxy if you need/want it, but I did not need it.
I included a boring keyholder that printed in ~3 hours at .2mm layer height and 70mm/s as well so you can put whatever or nothing at all on top.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!