Key Tag | With Hinge

An alternative version of my print-in-place keytag but with a common printed filament hinge. So you can print it in PLA without any concerns and do not have to use PETG. The keytag consists of 2 separate parts that are connected with a piece of 31mm long filament. It is printed flat on the print bed so you can make use of your different print plate textures. It closes with a nice press fit and shouldn't open even when dropped from normal standing height. Print Settings0.2mm layer heightno supports4 walls4 bottom shell layers5 top shell layerswall generator: arachnetransitioning threshold angle: 30° DimensionsLenght 54mmWidth 25mmHeight 3.5mm Keychain Holes: 5mm3.5mm Additional Parts1 x 31mm piece of filament (Ø 1.75mm) Assembly Cut a 31mm long piece from your filament, thread it into the hinge and push it all the way in with some pliers for example. NoteMake sure you have dried your Filament properly and use a clean build plate. OptionalOnce you tested the print you can duplicate t