Thingiverse
Keybow 2040 Case
von marzsman
15
Downloads
14
Likes
1
Makes
I designed a little case for the Keybow 2040 from Pimoroni.
I wanted it to be as basic as possible so there are no holes for the BOOTSEL and reset button, only for the USB-C cable.
The Keybow fits nicely into the bottom box. The top clips onto the bottom and prevents the keybow from falling out. Everything should stay together without any screws or glue.
At the bottom of the case I added some small clear bumper pads so it doesn't move around on my desk while using it.
I wanted it to be as basic as possible so there are no holes for the BOOTSEL and reset button, only for the USB-C cable.
The Keybow fits nicely into the bottom box. The top clips onto the bottom and prevents the keybow from falling out. Everything should stay together without any screws or glue.
At the bottom of the case I added some small clear bumper pads so it doesn't move around on my desk while using it.
marzsman veröffentlicht auch auf
16 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
