Keycap Puller: Print-in-Place

Keycap Puller: Print-in-Place---------------------------------------------------------------------------------About:Print-in-place keycap puller that safely removes keycaps from a mechanical keyboardInspired by Nikoraasu's keycap pullerPrinted with NO supports, as the file has built-in supportsPrinted in less than 25 minutes on a standard MK3S---------------------------------------------------------------------------------Printing:Tested with PLA and PETGDisable supportsEnable bridging3 perimeters15% infill3mm brim recommended---------------------------------------------------------------------------------Post-Processing:To remove the built-in supports, I used a stiff thin board to slide between the two halves.Use clippers to remove the excess filament---------------------------------------------------------------------------------Design Process:<img src="https://makerworld.bblmw.com/makerworld/draft/223039/20