Keyholder (swiss type, multi-tool type)

Hello Makers,

this is a swiss army knife type keyholder.

At one side it supports keys with 6 mm holes, on the other side supports key holes from 4mm or keys with special bows. There is also a latch to secure special keys if needed.

To assemble this keyholder, you need 2 pcs of M3 nuts + 1pc of M3 x 16 screw + 1pc of M3 x 20 screw + 2 pcs of M3 washers.

Printing time took me ~ 2 hours. (100% infill, no supports)

Good luck for printing! :)

Adam