Thingiverse
Keymod Mini AFG
di Concealed45
74
Download
35
Likes
1
Makes
Small AFG for Keymod rail, Odinworks inspired. Small but comfortable for a good hand angle if using a thumb over bore grip.
I could only get it on with just the rear pin in place with the keymod screws i had which seemed short. It is still on there very solid.
Print laying on its side with support only for 80 degree overhangs. I used PETG and .2 layer at 55mm per sec, 30% infill in Cura.
I could only get it on with just the rear pin in place with the keymod screws i had which seemed short. It is still on there very solid.
Print laying on its side with support only for 80 degree overhangs. I used PETG and .2 layer at 55mm per sec, 30% infill in Cura.
Concealed45 pubblica anche su
27 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!