Thingiverse
Keymove DK61 Feet
2
Download
1
Likes
0
Makes
These are replacement feet for the keymove DK61 shadow/snowfox keyboards. These are drop in replacements (albeit a very snug fit) for the existing feet. You carry over the rubber pads from the old/broken feet to the new ones.
I just printed it with my standard 0.20mm profile, so it probably printed them solid. Something slightly more flexible than standard PLA would be preferable, but it does the job.
Only use supports on the side shafts, don't add any in the center, us a support blocker or manually add supports to the pins.
I just printed it with my standard 0.20mm profile, so it probably printed them solid. Something slightly more flexible than standard PLA would be preferable, but it does the job.
Only use supports on the side shafts, don't add any in the center, us a support blocker or manually add supports to the pins.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
