MakerWorld
Hand Tools
Go to Model
Keyring bit driver - Magnetic
2
Downloads
1
Likes
3
Makes
Ultra minimal keyring bit driver with two bit storage. Fully magnetic. As slim and minimal as possible to be as EDC-friendly as possible. The two bit chambers have slightly different dimmension in the design so that when printed and shrinking slightly differently, the two chambers have as close to the same size and feel as possible, making it feel high quality. Very fidget friendly. 2 versions:Version A - 1x 6x2mm + 2x 5x2mm magnets - Most recommended, minimal magnetic field.Version B - 3x 6x2mm magnets.Install:I used a Q-tip with one side cut off to apply super glue inside magnet pocket. Then a hex driver to insert the magnet. Hope you like it!Boost Me
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
