Thingiverse
Keystone Ceiling Mount
von Dovraga
15
Downloads
7
Likes
0
Makes
RJ45 Keystone Ceiling Jack
Insert the into the backing and twist to lock. Twist again to unlock for access.
Easy to install and minimal cutting required versus using a regular faceplate and mount.
Requires a 38mm (1.5 Inches) hole to be drilled (found in most hardware stores/hole saw kits) and to have access to both sides of the board/wall. Glue can help, but not necessary to mount the backing.
Just raise or lower the height depending on the thickness of the board (default is 0.75 Inches or 19-20mm thick).
Update 15/7/2021: Added a recessed and partially recessed variant
Insert the into the backing and twist to lock. Twist again to unlock for access.
Easy to install and minimal cutting required versus using a regular faceplate and mount.
Requires a 38mm (1.5 Inches) hole to be drilled (found in most hardware stores/hole saw kits) and to have access to both sides of the board/wall. Glue can help, but not necessary to mount the backing.
Just raise or lower the height depending on the thickness of the board (default is 0.75 Inches or 19-20mm thick).
Update 15/7/2021: Added a recessed and partially recessed variant
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
